Asko Dishwasher F10 Error Code
A display reading F10 means the Asko dishwasher has detected overfilling of the first kind. The manuals send owners to the drain pump.
Model Reference
Asko DFI786 Dishwasher Repair in San Francisco
A 24-inch Asko dishwasher with a short spec sheet, handled by checking the installation as much as the machine.
- 7appliance guides
- 38model pages
- 72error codes explained
- 150Bay Area places
- Mon–Sat8:00 AM – 7:00 PM
Model number
DFI786
About this model
Model overview
Short sheet, long list of ways a dishwasher can fail. The DFI786 is an Asko dishwasher with a 24-inch width and an ENERGY STAR available entry dated February 2023. Series and sale status are not recorded for it, so we leave them out.
Start with the sound and the smell
How the machine fails tells us where to look. A hum without water movement suggests the pump is stalled or blocked. A hot, scorched odour means power off at the breaker, then a call. A sour smell after the cycle usually points to standing water or a dirty filter basket rather than a defect.
Fill, wash, drain: where each fails
| Stage | What goes wrong | What a technician checks |
|---|---|---|
| Fill | No water, slow fill, overfill | Supply valve, inlet hose, inlet valve, level sensing |
| Wash | Dirty dishes, weak spray, noise | Spray arms, circulation, heating |
| Drain | Water in the tub afterwards | Screen, hose route, drain pump |
The cabinet it lives in
Built-in dishwashers in Victorians and in-law units often sit beside a very old sink drain. Narrow cutouts leave no room to inspect the rear hoses, so the technician may need to slide the unit out. If the cabinet or countertop is attached to the dishwasher, tell us when you book.
Things you can do yourself
- Switch the machine off at the breaker and back on once; note whether the code returns.
- Make sure the supply valve under the sink is fully open.
- Take out and rinse the tub filter.
- Check the drain hose for a visible kink if it is reachable.
Leave the lower access panel on; opening panels is for the technician.
Where to go next
Our overview Asko dishwashers lists the range, and Asko dishwasher repair explains the visit. If your screen shows an F-number, the Asko dishwasher F12 error code page describes a water inlet fault. A related listing is Asko DBI786 repair.
Why the written estimate matters
Dishwasher faults can overlap, so a single symptom may carry two causes: a worn seal and a loose hose, or a blocked screen and a weak pump. The written estimate lists what the technician found in plain words, so you can see which items are needed and which are optional before you approve anything.
Frequently asked questions
Yes, the listing gives 24 inches.
We hold no availability status for it, so we do not say.
Test equipment for the inlet path and notes from your description. Parts are only ordered after you approve the estimate.
Switch it off, clean the filter if you can reach it, and book a diagnosis. Running it again may strain the pump.
Not required. The model number and your description are enough to begin.
Model-information disclaimer. Confirm your exact model number and specifications with your appliance documentation before booking a repair. Model pages are for identification and compatibility reference.
Diagnostics
Error codes for this appliance
Fix it right
Repair service
Dishwasher Repair in San Francisco
Diagnosis and repair for 24-inch built-in Asko dishwashers across San Francisco and the Bay Area, from drain faults and F-codes to leaks…
Models
Other models
Book a repair
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Phone
(415) 993-3547
Hours
Mon–Sat: 8:00 AM – 7:00 PM
Service area
San Francisco Bay Area, California